Stereo Line In Devices; Headphones; Telephone Lines; Mouse, Keyboard Or Keypad - Fujitsu LifeBook C-4120 Manual

STEREO LINE IN DEVICE
Make sure that your stereo line in audio device,
a cassette recorder, for example, is equipped
with an 1/8" (3.5 mm) stereo mini-plug. Make
sure the plug is aligned and push it into the jack
until fully seated. (See Figure 1-6 on page 8.)

HEADPHONES

Make sure that your stereo headphones are
equipped with an 1/8" (3.5 mm) stereo mini-
plug. Make sure the plug is aligned and push
it into the jack until fully seated.
(See Figure 1-6 on page 8.)
P O I N T
Plugging in headphones disables the
built-in stereo speakers.

TELEPHONE LINES

To attach a telephone line to the internal
modem open the rear panel connector cover or
with the cover closed slide the panel in the con-
nector cover slightly opened to reveal the
Modem (RJ-11) jack. Plug one end of the tele-
U s e r I n s t a l l a b l e
phone cable into the telephone line outlet.
Orient the telephone cable with the release latch
on the connector up. Push it into the jack until
it clicks and latches. (See Figure 1-6 on page 8.)
C A U T I O N
The internal modem is not intended for
use with Digital PBX systems. Do not
connect the internal modem to a digital
PBX as it may cause serious damage to
the internal modem or your entire note-
book. Consult your PBX manufacturer's
documentation for details. Some hotels
have Digital PBX systems. Be sure to find
out BEFORE you connect your modem.

MOUSE, KEYBOARD OR KEYPAD

Make sure the connector on your device is
the correct PS/2 type. Align the arrow on the
connector to point to the bottom of your note-
book and push it in until the connector seats.
A mouse, keyboard or keypad may be installed
L i f e B o o k C S e r i e s f r o m F u j i t s u
F e a t u r e s
and automatically recognized by your note-
book without restarting or changing setups.
(See Figure 1-7 on page 9.)

EXTERNAL MONITOR

You may install an external monitor on the
external monitor port on the rear panel of your
notebook. Make sure that the wide side of the
connector is down and attach it to the port by
pushing in until it is seated, then tighten the
hold-down screw on each end of the connector.
(See Figure 1-7 on page 9.)
C A U T I O N
Pressing F10 while holding down the Fn
key allows you to change your selection
of where to send your display video. Each
time you press the combination of keys
you will step to the next choice. The
choices, in order, are: built-in display panel
only, external monitor only, or both built-
in display panel and external monitor.
53