Fujitsu 985Tx User Manual page 64

S e c t i o n T h r e e
3. The Main Menu of the setup utility then
appears with the current settings of the para-
meters displayed.
4. If you wish to go to one o f the other setup
menus, press the or the key to find the
menu you require.
P O I N T
If your data security settings require it,
you may be asked for a password before
the Main Menu will appear.
Entering the Setup Utility After a
Configuration Change or System Failure
If there has been a change in the system config-
uration that does not agree with the parame ter
settings stored in your BIOS memory, or there
is a failure in the system,the system beeps
and/or displays an error message after the
Power On Self Test (POST). If the failure is
not too severe,it will give you the opportunity
to modify the settings of the setup utility, as
described in the following steps:
54
1. When you turn on or restart the computer
there is a beep and/or the following message
appears on the screen:
Error message – please run SETUP
p r o g r a m
Press <F1> key to continue, <F2>
to run SETUP
2. If an error message is displayed on the screen,
and you want to continue with the boot
process and start the operating system
anyway, press the F1 key.
C A U T I O N
If your notebook beeps a series of beeps
that sounds like a code and the display is
blank, please refer to the Troubleshooting
Section. (See pages 145.)
The Troubleshooting Section includes a
list of error messages and their meanings.
(See pages 148–150.)
P O I N T
If your data security settings require it,
you may be asked for a password before
the operating system will be opened.
3. If an error message is displayed on the screen,
and you want to enter the setup utility, press
the F2 key.
4. When the setup utility starts with a fault
present,the system displays the following
message:
W a r n i n g !
Error message
[ C o n t i n u e ]
5. Press any key to enter the setup utility. The
system will then display the Main Menu with
current parameter values.