Fujitsu 985Tx User Manual page 127

S e c t i o n F o u r
Connecting Devices to the
LANdock or Port Replicator
Connect devices to your LANdock or Port
Replicator in exactly the same way you would
your notebook.Figure 4-18 shows the location of
LANdock ports and jacks.Figure 4-20 shows the
location of the Port Replicator ports and jacks.
To Remove Your Notebook from
the LANdock
1. From the Start menu click on Eject PC
or press the Undock Request Button on
the LANdock.
2. Wait for the Safe to Undock LED to illumi-
nate and the system to go to Suspend mode,
even if a message appears on your screen
saying that you may undock.
3. Push the lever on the side of the docking
device backward until the docking device
connectors are completely clear of
your notebook.
4. Very carefully lift your notebook clear of the
alignment pins in the bottom.
118
To Remove Your Notebook
from the Port Replicator
1. Put your notebook in Suspend mode or
turn off the power.
2. Push the lever on the side of the station
backward until the docking device connec-
tors are completely clear of your notebook.
3. Very carefully lift your notebook clear of
the Port Replicator.
C A U T I O N
You may lose information if you do not
wait for the system to go to Suspend
mode before removing your notebook
from the docking device
P O I N T
If the notebook power switch is turned
off it is always safe to undock. You do
not have to turn on your notebook and
use the Eject PC feature for the LANdock
or put your notebook in Suspend mode
for the Port Replicator.
C A U T I O N
The RJ-11 connector on the rear of your
docking device comes with a protective
cover to keep the connector clean. Be
careful to remove it before trying to make
a connection. Save the cover and replace
it when the connector is not in use.