Table of Contents
Advertisement
S e c t i o n
F o u r
PARALLEL PORT DEVICES
To connect a parallel interface device to the par-
allel port, be sure that the connector is the right
size and aligned,then push in until it is fully
seated. When it is seated tighten the hold-down
screws, one on each end of the connector.
(See Figure 1-9 on page 8.)
SERIAL PORT DEVICES
To connect an RS-232C device to the serial
port, be sure that the connector is the right size
and aligned,then push in until it is fully seated.
When it is seated tighten the hold-down screws,
one on each end of the connector.
(See Figure 1-9 on page 8.)
USB DEVICES
When installing a device on the USB Port, be
sure that the connector is the right size,aligned,
and fully seated. (See Figure 1-8 on page 7.)
C A U T I O N
Due to ongoing changes in USB technology
and standards not all USB devices and/or
drivers are guaranteed to work.
124
MICROPHONE
Make sure that your mono microphone is
equipped with an 1/8" (3.5 mm) mono mini-
plug. Make sure the plug is aligned and push it
into the jack until fully seated. (See Figure 1-8
on page 7.)
STEREO LINE IN DEVICE
Make sure that your stereo line in audio device,
a cassette recorder, for example,is equipped
with an 1/8" (3.5 mm) stereo mini-plug. Make
sure the plug is aligned and push it into the jack
until fully seated. (See Figure 1-8 on page 7.)
HEADPHONES
Make sure that your stereo headphones are
equipped with an 1/8" (3.5 mm) stereo mini-
plug. Make sure the plug is aligned and push
it into the jack until fully seated.
(See Figure 1-8 on page 7.)
P O I N T
Plugging in headphones disables the
built-in stereo speakers.
TELEPHONE LINES
To attach a telephone line to the internal
modem open the rear panel connector cover or
with the cover closed slide the panel in the con-
nector cover slightly opened to reveal the RJ-11
jack.Plug one end of the telephone cable into
the telephone line outlet.Orient the telephone
cable with the release latch on the connector
up. Push it into the jack until it clicks and
latches. (See Figure 1-9 on page 8.)
C A U T I O N
The internal modem is not intended for
use with Digital PBX systems. Do not
connect the internal modem to a digital
PBX as it may cause serious damage to
the internal modem or your entire note-
book. Consult your PBX manufacturer's
documentation for details. Some hotels
have Digital PBX systems. Be sure to find
out BEFORE you connect your modem.
Hide quick links:
Advertisement
Table of Contents
