Parallel Port Devices; Serial Port Devices; Usb Devices; Microphone - Fujitsu Lifebook C340 Manual

S e c t i o n F i v e
Removing PC Cards
If you wish to remove or replace the PC Card,
use the following procedure:
1. Shutdown operation of the card.
2. Click on the PC Card indicator on the
Windows taskbar.
From the PC Card Properties Window:
3. Select the card to be removed and click
on the Stop button.
4. Verify that the You can safely
remove your card message appears.
5. If the device cannot be removed
message appears, save all files, close all
applications, and exit Windows 98 then shut-
off the power with the power switch.
(See Power Off on pages 20-21.)
100
C A U T I O N
If the PC Card has an external connector
and cable, do not pull on this cable when
removing the card.

PARALLEL PORT DEVICES

To connect a parallel interface device to the par-
allel port, be sure that the connector is the right
size and aligned, then push in until it is fully
seated. When it is seated tighten the hold-down
screws, one on each end of the connector.
(See Figure 1-6 on page 9.)

SERIAL PORT DEVICES

To connect an RS-232C device to the serial
port, be sure that the connector is the right size
and aligned, then push in until it is fully seated.
When it is seated tighten the hold-down screws,
one on each end of the connector.
(See Figure 1-6 on page 9.)

USB DEVICES

When installing a device on the USB Port, be
sure that the connector is the right size, aligned,
and fully seated. (See Figure 1-6 on page 9.)
C A U T I O N
Due to ongoing changes in USB technology
and standards not all USB devices and/or
drivers are guaranteed to work.

MICROPHONE

Make sure that your mono microphone is
equipped with an 1/8" (3.5 mm) mono mini-
plug. Make sure the plug is aligned and push it
into the jack until fully seated. (See Figure 1-5
on page 7.)
STEREO LINE IN DEVICE
Make sure that your stereo line in audio device,
a cassette recorder, for example, is equipped
with an 1/8" (3.5 mm) stereo mini-plug. Make
sure the plug is aligned and push it into the jack
until fully seated. (See Figure 1-5 on page 7.)

HEADPHONES

Make sure that your stereo headphones are
equipped with an 1/8" (3.5 mm) stereo mini-
plug. Make sure the plug is aligned and push
it into the jack until fully seated.
(See Figure 1-5 on page 7.)