Optional Landock Or Port Replicator - Fujitsu 985Tx User Manual

Total RAM System
Installed Memory
112MB 640K
128MB 640K
144MB 640K
160MB 640K
If the total memory displayed is not what you
believe it should be, check that your memory
upgrade modules are properly installed; if
properly installed and the capacity is not
correctly recognized. (See the Troubleshooting
Section starting on page 126.)
C A U T I O N
Follow the instructions that came
with your LANdock or Port Replicator.
The instructions and illustrations in this
manual are only to serve as a guideline.
The LANdock or Port Replicator manual
that is included with the docking device
supersede these instructions.
U s e r I n s t a l l a b l e
Extended
OPTIONAL LANDOCK OR
Memory
PORT REPLICATOR
The LANdock or Port Replicator (docking
112M
device) is powered from an AC adapter.
128M
To Install your Notebook
144M
in a Docking Device:
1. Put your notebook in Suspend mode or turn
160M
off the power.
2. To use a docking device with your notebook
they both must be on a flat surface.
3. Remove all connections from the rear panel of
your notebook. (See Figure 1-7 on page 8.)
4. Make sure that the adjustment feet are flat
against the bottom of the notebook and the
covers of the connectors, both rear panel and
right side panel,are closed.
5. Make sure that the slide cover in the rear
panel is completely open.
6. Set your notebook on the leveler, making
sure that the alignment pins on the leveler
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
(Figures 4-17 and 4-19) fit into the Docking
Alignment receptacles in the bottom of your
notebook. (Figure 1-8 on page 10.)
7. Arrange the notebook/leveler combination to
align the docking connector on the docking
device body with the Docking port on your
notebook and the notches on the leveler with
the notches on the docking device body.
(Figure 4-16.)
8. Push together firmly.
9. Lock in place by pulling the Docking Release
lever forward.
10. For the LANdock only, verify that docking is
complete by checking that the LifeBook
Docked LED is il luminated. (Figure 4-17.)
11. Return your notebook to operation using
the Suspend/Resume button or power
switch,as appropriate. (When setting
up the LANdock for the first time you must
use the power switch.)
117