Table of Contents
Advertisement
With 10 channels of arbitrarily programmable input points, the system defaults to 4 groups
for fixed functions as follows:
1. A set of maintenance switch inputs (IN1): All floors can pass when the maintenance
switch has a signal, until the maintenance switch signal disappears and the controller returns
to normal operation.
2. A set of fire switch trigger input (IN2): When the fire switch is triggered, all floors can
pass until the fire switch is triggered or the controller is reset to resume normal operation.
3. A group cancels the fire switch trigger input (IN3): When the fire switch is canceled, the
controller returns to normal operation.
4. A group of visitor mode selector switch (IN10): Press the button connected to the
LPU8110 board IN10 and then swipe the card to the guest mode. After swiping the card,
press all authorized floors. If you do not press this button to swipe, it is in normal mode (ie,
home mode). The system actively opens the only self-occupied floor (the self-occupied floor
number is set in the PC software)
2.6 DIP Switch
l
Switch S1（Unit ID）
The DIP switch S1 has a total of 8 bits. The first 1 to 7 bits are the address of the DIP switch,
and the DIP8 is the initialization switch. Power off or pressing the reset button will cause the
parameter to initialize.
(G?' !J+'
(G?' 3HH['
(G?':'
DIP
1
(%)#*+,&+"-'
\-+&''G('
*%)%&]'
CMMHH(%D0=E&'
CBHH''.%)%&'
1
2
3
4
!
Figure 2-1-5 DIP Switch 1
2
3
DE""*W'
5
6
7
8
!
!"#$%
4
5
6
.%/0*$'
0
1
2
M = N*2
+ N*2
+ N*2
+ N*2
4
5
6
!N=0 or 1
N*2
+ N*2
+ N*2
@E%0*'70&0V'
+-+&+0E+>0&+"-'
7
8
3
+
Advertisement
Table of Contents
