Table of Contents
Advertisement
Hardware Setup
Break/Suspend Connector
The Break/Suspend connector is a two-pin connector labeled JP17 on the
system board. Pressing the break switch on the front bezel forces the system
to enter the suspend mode. Pressing any key on the keyboard returns the
system to normal mode.
The AP55CS does not support the turbo
function. Therefore, we recommend that you
connect the turbo switch to JP17.
Voltage Regulator Module (VRM) Connector (optional)
The optional VRM connector is designed to accommodate a voltage
regulator module to support future CPUs. This connector is marked CN5 on
the board. See the board layout figure in Chapter 1 for the exact location of
the connector.
Installation
The baby-AT size of the system board easily fits most housings. It has
mounting holes that conform to the standard system housing.
Some housings may differ slightly in design, requiring additional steps to
install the board. Read the documentation that comes with the housing.
2-18
User 's Guide
Advertisement
Table of Contents
