Hit "Del" Message Display; Extended Bios Ram Area; Wait For F1 If Any Error; System Boot-Up Num Lock - AOpen AP55CS User Manual

Hit "Del" Message Display

This option lets you enable or disable the Hit <Del> if you want Setup
message from appearing when the system boots. The default setting
is Enabled .

Extended BIOS RAM Area

This function allows you to relocate the BIOS from ROM to RAM.
Relocating to RAM enhances system performance as information
access is faster than ROM. The parameter settings are 0:300 and
DOS 1K. The default address is

Wait for F1 If Any Error

If this option is enabled, the BIOS waits for the end user to press l
before continuing. If this option is disabled, the BIOS continues the
boot process without waiting for l to be pressed. The default setting
is Enabled .

System Boot-up Num Lock

Setting this parameter to
numeric keypad. Set this parameter to
function. Disabling the numeric function allows you to use the
numeric keypad for cursor control. The default setting is

Floppy Drive Seek at Boot

When enabled, the BIOS detects whether there is a floppy disk drive
installed. Disable the parameter to bypass the function. The default
setting is
Enabled.
User's Guide
AMI BIOS
0:300
.
enables the numeric function of the
On
Off to disregard the
On
.
4-9