Table of Contents
Advertisement
ports, one parallel port and FDD functions. Set the jumper to 2-3 in case you
want to use a separate I/O card.
JP14
Selecting the Cache Mode
The motherboard comes with a 256-KB pipelined-burst cache that supports
both the linear and the interleave cache modes. The onboard three-pin
jumper JP1 enables you to set the cache mode depending on the CPU type in
use. Select linear mode if the CPU in use is a Cyrix CPU. For an Intel CPU,
select interleave mode. The default setting is 2-3.
CACHE MODE
Linear (Cyrix)
Interleave (Intel)
Enabling the Onboard VGA
The jumpers JP4, JP6 and JP7 let you enable or disable the onboard SiS
6205 VGA controller. This VGA controller enhances the display resolution
of the system. It supports a maximum resolution of 1280 x 1024, 256 colors,
NI.
User 's Guide
Hardware Setup
Enabled
Disabled
JP1
2-7
Advertisement
Table of Contents
