Assembling The Stand - Dürkopp Adler 650-16 Operating Manual

11.3 Assembling the stand

Steps
1. Fasten pedal (2) to the cross-member (1).
2. Secure the additional pedal (3 - optional) to the cross-member
3. Attach the cross-member (1) to the frame.
4. After fully assembling the machine, align the pedals.( Chap.
5. Bolt the encoders (4) and (7) onto the frame strut (5). Distance
6. Screw the cable duct (6) (30 x 30 x 250 mm) for the encoder
7. Turn adjusting screw (8) to ensure the stability of the frame.
52
Fig. 42: Assembling the stand
4
(1) - Cross member
(2) - Main pedal
(3) - Additional pedal
(4) - Encoder for additional pedal
brace (1).
11.5 Attaching the table top and the pedals to the frame, p. 54)
between the floor and the top edge of the frame strut (5):
290 mm.
onto the frame strut (5).
The frame must rest with all four feet flush on the floor.
6
7
5
3 2
(5) - Frame strut
(6) Cable duct
(7) Encoder for main pedal
(8) - Adjusting screw
Instruction manual 650-16 Version 00.0 - 07/2013
Installation
8
1