Indoor ONT Installation
NOTE
The Electronics Module must be installed in a Restricted Access location.
Mounting the Outdoor ONT (P/N 1287703G1) in an Indoor location requires the use of the
Total Access 374 Wall Mounting Bracket (P/N 1187781G1).
To mount the bracket and ONT, perform the following steps:
1. Attach the Mounting bracket to the wall using the holes in the bracket as a template.
2. Use materials suitable to the wall surface and structure. The Electronics Module weighs
3. Align the slots on the Mounting Bracket with the tabs on the ONT and snap the two units
61287703G1-5B
Refer to
Figure
2-14.
approximately 2.25 lbs (1 kilogram).
Figure 2-14. Indoor Mounting Bracket
together. Refer to
Figure
Section 2, Installation and Testing - Indoor ONT Installation
2-15.
Mounting Holes
2-23