Installation Of Ups; Figure 2-12. Ups Power Connection - ADTRAN Total Access 374 Installation And Maintenance Manual

Installation of UPS

NOTE
Installation of the Uninterruptible Power source (UPS) will be dictated by on-
site conditions and local telephone company practices. Refer to the
installation material provided with the UPS. When installing the UPS, refer to
the UPS manufacture's mounting instructions where possible.
To install the uninterruptible power supply (UPS) complete the following steps:
1. Select a location for the UPS. When making this determination, consider the following:
2. Use the template enclosed with the unit to mark the installation location.
3. Remove the battery cover from the UPS unit and remove the strap from the battery
4. Disconnect the battery cable at the battery terminals if already connected to the battery.
5. Remove the battery, if installed.
6. Mount the UPS using screws appropriate for the total weight of the UPS and the
7. Refer to
61287703G1-5B
■ This unit is not appropriate for outdoor placement.
■ Place the UPS in a safe area, free of excessive dust, and with adequate airflow.
■ Refer to UPS technical specifications table for details on temperature and humidity
requirements. Do not operate outside these specified limits.
holding it to the shelf of the unit.
mounting surface material.
Figure 2-12 and

Figure 2-12. UPS Power Connection

Section 2, Installation and Testing - Fiber Installation
Table 2-4 on page 2-20 to Connect the UPS cable wires.
+
2-19