Figure 2-6. Optitap Installation - ADTRAN Total Access 374 Installation And Maintenance Manual

Total Access 374 4-POTS, 4-GigE MDU ONT Installation and Maintenance Guide
Bulkhead
Connector
5. Splice the incoming fiber to the OptiTap Connector using a Fiber Optical Fusion Splice
6. Route the Fiber Jumper that attaches to the Electronics Module to the Bulkhead
7. Tie wrap the Incoming Fiber Cable to the entry port.
2-12
Tool.
connector. This will help keep the optics clean. The connection from the bulkhead
connector to the electronics module is completed in the
page 2-14.

Figure 2-6. OptiTap Installation

Fiber
Jumper
Note:
Connect the Fiber Jumper
to the Bulkhead connector
until it is terminated in the
Fiber Termination step.
"Fiber Termination" section on
61287703G1-5B