ADTRAN Total Access 334 Manual

CLEI: BVMBP10F_ _
Product P/N: 1287736G3
Documentation for ADTRAN Carrier Networks products is
available for viewing and download directly from the
ADTRAN Support Community website.
Go to:https://supportforums.adtran.com/welcome
Registration is required.
ADTRAN offers training courses on our products, including
customized training and courses taught at our facilities or at
customer sites.
For inquiries, go to: http://adtran.com/training
D
ESCRIPTION
This Job Aid supports the Total Access 334 Indoor 3rd Generation
Single Family Unit (SFU) Optical Network Termination (ONT). The
illustration above displays the rear of the SFU ONT and a cut-away of
the top depicting status LEDs.
Ports/Connectors
■ 2 POTS Ports
■ 4 Gigabit Ethernet Ports
■ DC Power Plug
■ UPS Connector
■ CATV
■ SC Fiber Connector (located behind the protector panel labeled
"Fiber Port". Refer to "Installing Fiber"
information.)
Resetting the ONT
A reset button is available if the SFU ONT needs to be rebooted. To
reset the SFU ONT, press the RESET button for 5 seconds or longer.
The RESET button is located next to the USB port.
!
WARNING
All settings will return to Factory Defaults: Registration provisioning
will be lost.
Voice Processing
POTS uses in-band signaling tones and currents to determine call
status (for example, call request). Because POTS allows for the
transfer of audio signals below 3.3 kHz, POTS systems are also used
for modems that allow data transmission (referred to as dial up
connections).
Total Access 334
Indoor 3rd Generation SFU ONT
The following related online documents and resources provide additional information for this product:
Total Access 5000 Series Fiber to the Premises Deployment Guide
Total Access 5000/5006 Engineering Guide
POWER BATTERY FAIL ETH4
ON/OFF PWR UPS POTS1 POTS2
on page 2 for installation
with RF
ETH3 ETH2 ETH1 POTS MGMT
ETH1 ETH2 ETH3 ETH4
Ethernet Interface
The SFU ONT supports data service through four 10/100/1000Base-T
Ethernet interfaces via an RJ-45 connector.
Power
The power feed is 12 VDC. The total power consumption with 4
Ethernet ports running, and all lines off-hook is approximately 7.2
Watts.
The SFU ONT uses a standard DC barrel-type connector as a primary
power source. A connection for an optional un-interruptible power
supply (UPS) is provided.
Fiber
Fiber is supplied to the SFU ONT using an SC Fiber connection
located behind a removable protective panel.
UPS
The SFU ONT provides an optional connection for an UPS. An UPS is
a battery backup system designed to continue providing power when
the primary power source is lost. Power is supplied to the SFU ONT
by a local power source with battery backup that utilizes the AC
power at the customer premises.
CATV
The SFU ONT provides a coaxial connection that can be used to
access cable television programming.
I
NSTALLATION
After unpacking the SFU ONT, inspect it for damage. If damage is
noted, file a claim with the carrier and then contact ADTRAN. For
more information, refer to the warranty.
jobAid
Issue Date: April 2015
Document P/N: 61287736G3-22B
WLAN
Fiber Port
CATV
1