Table of Contents
Advertisement
Install Electronics Module
NOTE
In all the following illustrations, the cover of the Electronics Module has been
removed for clarity purposes. This procedure applies to both the Straight
Fiber and OptiTap Installation procedures.
Refer to
1. Connect a fiber jumper to the bottom of the bulkhead connector and the route the Fiber
2. Align the tabs on the electronics Module with the snaps on the NID Housing and snap
3. Align the captive screw on the bottom of the Electronics Module with the screw hole on
61287703G1-5B
Figure 2-7
for instructions on installing the Electronics Module in the NID Housing.
Jumper from the Bulkhead connector through the Fiber Guide as shown in
page 2-15.
the two together.
the Ground Bar and tighten.
Figure 2-7. Electronics Module Installation
Section 2, Installation and Testing - Fiber Installation
Figure 2-9
on
2-13
Advertisement
Table of Contents
Troubleshooting
