Total Access 300 Series Active Ethernet Single Family Unit ONT Installation and Maintenance Guide
Electronics Module
The Electronics Module (see
use in outdoor applications. The Electronics Module may already be installed in the housing.
Installation and removal can be accomplished by gently pulling the module from the hinge
points on the housing.
3-8
Hinge
Point
TELEPHONE TROUBLESHOOTING
1. Identify the bad line.
2. Disconnect the plug from the appropriate POTS jack and plug
any working telephone into that jack.
If the telephone works, there is a problem inside the house.
If the telephone does not work, contact your service provider.
3. Remove the telephone and replace the plug into the POTS jack.
4. Close the unit.
12V
Hinge
Point
Figure 3-4. Total Access 354E Electronics Module
Figure
3-4) is designed for insertion into the Outer Enclosure for
POWER
NETWORK STATUS
POTS 1
POTS 2
TOTAL ACCESS 354E
1287704G1
TELCO ACCESS
, 1.5A
TIP/RING
ETH 1
ETH 2
ETH31
TEL. NUMBER
CLEI
Telco Access
Security
Screw
612877AEONT-5B
POTS 1
POTS 2
ETH 4