Cooling System Maintenance; Servicing The Cooling System - Toro Z Master Professional 7000 Series Operator's Manual

16. Install the rubber clutch strap to the mower
frame with the 2 previously removed bolts and
nuts (Figure 69).
17. Pull up on the spring-loaded idler for the
PTO-drive belt and install it onto the clutch
pulley (Figure 68).
18. Plug in the electric connection for the clutch
(Figure 69).
19. Install the front engine panel and tighten the
knobs.
20. Lower down the seat.
Cooling System
Maintenance
Servicing the Cooling
System
DANGER
Discharge of hot pressurized coolant or
touching hot radiator and surrounding parts
can cause severe burns.
• Do not remove the radiator cap when the
engine is hot. Always allow the engine to
cool at least 15 minutes or until the radiator
cap is cool enough to touch without
burning your hand before removing the
radiator cap.
• Do not touch the radiator and surrounding
parts that are hot.
DANGER
The rotating shaft and fan can cause personal
injury.
• Do not operate the machine without the
covers in place.
• Keep your fingers, hands, and clothing
clear of rotating fan and driveshaft.
• Shut off the engine and remove the ignition
key before performing maintenance.
CAUTION
Swallowing engine coolant can cause
poisoning.
• Do not swallow engine coolant.
• Keep out of reach from children and pets.
Checking the Radiator Coolant
Service Interval: Before each use or daily
After the first 8 hours
Every 100 hours
Fluid Type: 50/50 mix of extended life
antifreeze/Dex-Cool® and water
Cooling System Capacity: 4.6 L (156 oz)
Note:
Do not open the radiator cap. Doing this may
induce air into the cooling system.
53