Toro Z Master Professional 7000 Series Operator's Manual page 62

5. Remove the cap from the filler neck and look
inside to check if there is fluid in the reservoir
(Figure 86).
6. If there is no fluid, add fluid to the reservoir until
it reaches the cold level of the baffle.
7. Run the machine at low idle for 15 minutes to
allow any air to purge out of the system and
warm the fluid; refer to
the Engine (page
Note:
Check the fluid level while the fluid is
warm. The fluid should be between cold and hot.
8. If required, add fluid to the hydraulic tank.
Note:
The fluid level should be to the top of
the hot level of the baffle, when the fluid is hot
(Figure 86).
9. Install cap on filler neck.
Figure 86
1. Hot fluid level-full
Starting and Shutting Off
24).
2. Cold fluid level-full
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
• If hydraulic fluid is injected into the
skin it must be surgically removed
within a few hours by a doctor familiar
with this type of injury. Gangrene may
result if this is not done.
• Keep body and hands away from
pin hole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system before performing
any work on the hydraulic system.
• Make sure that all hydraulic-fluid
hoses and lines are in good condition
and all hydraulic connections and
fittings are tight before applying
pressure to hydraulic system.
g004819
62