Storage; Cleaning And Storage - Toro Z Master Professional 7000 Series Operator's Manual

Storage

Cleaning and Storage

1. Disengage the blade-control switch (PTO),
engage the parking brake, turn the ignition key
to the O position, and remove the key.
FF
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside of the engine cylinder
head fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
engine, hydraulic pumps, and motors.
3. Check the brake; refer to
(page 55).
Service the air cleaner; refer to
Cleaner (page 40).
Grease the machine; refer to
37).
4. Change the crankcase oil; refer to
Engine Oil (page
Check the tire pressure; refer to
Tire Pressure (page
Change the hydraulic filter; refer to
Hydraulic System (page
Charge the battery; refer to
(page 48).
Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
5. Check the condition of the blades; refer to
Servicing the Cutting Blades (page
Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows:
A. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
B. Shut off the engine, allow it to cool, and
drain the fuel tank; refer to
Fuel Tank (page
Note:
Start the engine and run it until it
shuts off.
C. Dispose of fuel properly. Recycle as per
local codes.
Brake Maintenance
Servicing the Air
Lubrication (page
Servicing the
41).
Checking the
50).
Servicing the
61).
Charging the Battery
70).
Servicing the
46).
Important:
stabilizer/conditioned fuel over 90
days.
6. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
7. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
8. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it out of reach of children or
other unauthorized users. Cover the machine to
protect it and keep it clean.
74
Do not store