Replacing The Pump Drive Belt; Replacing And Tensioning The Alternator Belt - Toro Z Master Professional 7000 Series Operator's Manual

8. Intall the rubber clutch stop.
9. Install the spring to the idler arm
1. Gearbox
2. Spring
3. Spring-loaded idler pulley
Replacing the Pump Drive
Belt
Service Interval: Every 50 hours—Check the pump
drive belt.
Note:
Remove the PTO-drive belt first if the pump
drive belt needs to be replaced.
1. Tilt the seat forward and remove the front engine
panel.
2. Remove the PTO-drive belt.
3. Remove the spring from the idler arm
80).
4. Install the new belt around the engine and
hydraulic pump pulley
5. Install the PTO-drive belt.
6. Install the spring to the idler arm
(Figure
Figure 79
4. Clutch
5. Rubber clutch stop
6. PTO-drive belt
(Figure
(Figure 80).
(Figure
79).
1. Clutch
2. Pump drive belt
g007176
Replacing and Tensioning
the Alternator Belt
Replacing the Alternator Belt
Service Interval: Every 50 hours—Check the
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the 4 bolts holding the oil cooler shield
to the rear frame
4. Remove the 3 bolts holding the engine straps to
the side of the machine
80).
58
Figure 80
3. Spring
4. Spring-loaded idler pulley
alternator belt.
EUTRAL
(Figure 81).
(Figure 81).
g007177
-
LOCK