Toro Z Master Professional 7000 Series Operator's Manual page 59

1. Oil cooler shield
2. Bolts
5. Remove the 4 bolts holding the oil cooler and
position the oil cooler to the side
6. Remove the 2 bolts holding the fan and fan plate
to the machine (Figure
1. Oil cooler
2. Fan
7. Loosen the bottom bolt and remove the upper
bolt holding the alternator and cover
8. Rotate the alternator cover to the side and
remove the belt from the pulleys and alternator.
9. Install a new belt around the pulleys and the
alternator (Figure
10. Install the fan and fan plate to the machine with
the 2 bolts previously removed
11. Install the oil cooler with the 4 bolts previously
removed (Figure
Figure 81
3. Engine straps
(Figure
82).
Figure 82
3. Fan plate
4. Alternator belt
(Figure
83).
(Figure
82).
12. Install the oil cooler shield and engine straps
to the rear frame with the 4 bolts previously
removed
13. Install the engine straps to the side of the
machine
14. Tighten the bottom bolt and install the upper bolt
holding the alternator and cover
g001295
82).
g001296
83).
82).
59
(Figure 81).
(Figure 81).
(Figure 83).