Stopping The Machine; Using The Side Discharge; Adjusting The Height Of Cut - Toro Z Master Professional 7000 Series Operator's Manual

Stopping the Machine

To stop the machine, move the traction control levers
to the N position and then to the N
EUTRAL
position, disengage the blade-control switch (PTO),
and turn the ignition key to the O
Engage the parking brake when you leave the
machine. Remember to remove the key from the
ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.

Using the Side Discharge

The mower has a hinged grass deflector that
disperses clippings to the side and down toward the
turf.
DANGER
Without a grass deflector, discharge cover, or
a complete grass-catcher assembly mounted
in place, you and others are exposed to blade
contact and thrown debris. Contact with
rotating mower blade(s) and thrown debris
will cause injury or death.
• Never remove the grass deflector from
the mower because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
• Never put your hands or feet under the
mower.
• Never try to clear the discharge area
or mower blades unless you move the
blade-control switch (PTO) to the O
position, rotate the ignition key to the O
position, and remove the key.
• Make sure that the grass deflector is in the
down position.
-
EUTRAL LOCK
position.
FF
FF
FF
28

Adjusting the Height of Cut

Adjust the height of cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. Raise the height-of-cut lever to the T
position (also the 127 mm (5 inches)
cutting-height position)
Figure 28
1. Height-of-cut lever
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 28).
3. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, and
insert the pin (Figure
4. Move the lever to the selected height.
RANSPORT
(Figure 28).
2. Pin
28).
g009568