Minolta Di251f Service Manual page 83

MODE 007 Factory setting bit : 1 0 1 1 1 0 0 1 (Hex : B9)
Bit Feature
765 Select upper limit of cut-
off length after printing.
432 Select upper limit of
reduction ratio of
received document.
1 Select cut off/reduction
of received document:
(This feature is enabled
when printing a received
document.)
0 Printing specification of
received document.
Logic Meaning
000
001 8 mm
* 010 12 mm
011 14 mm
100 18 mm
101 20 mm
110 24 mm
111 Not available
000 100 %
001 95 %
010 90 %
* 011 85 %
100 80 %
101 65 %
110 60 %
110 60 %
111 Not available
0 Reduction
1 Cut off
*
0 First page.
1 All pages.
S-39
0 When a received document is
longer than the print paper and if
the excess length is shorter than
that specified here, it is cut off. If it
is longer than that specified value
with these bits, it is split into
multiple pages. This feature is
enabled when the following 2
conditions are satisfied:
• When printing a received docu-
ment.
• When bit 1 of this mode is 1.
When a received document is
longer that the print paper, it will
be reduced to fit the paper with
the upper limit specified with
these bits. This feature is enabled
when the following 2 conditions
are satisfied:
• When printing a received docu-
ment
• When bit 1 of this mode is 0
Example: The reduction is 100-
90% when "90%" is specified.
Reduction will not be done if a
received document is still longer
than the paper for a specified
reduction.
This bit specifies cutting off or
reducing a received document
that is longer than the print paper.
This bit determines that the
received document will be cut off
with "Select upper limit of cut off
length after printing (MODE 007
Bit7-5)" or reduced with "Select
upper limit of reduction ratio of
received document (MODE 007
Bit 4-2)."
Specifies the timing when to start
printing the received document.
Description