Selecting Paper; Printing Area; Printing Mode; Automatic Reduction Mode - Minolta Di251f Service Manual

5.

SELECTING PAPER

5-1.

Printing Area

• The figure below shows the printable area on the paper.
• The minimum margins are 4 mm*.
*: The minimum margins can be adjusted with Edge erase adjustment.
5-2.

Printing Mode

• There are 2 printing modes available to this system. The soft switch (MODE 007) toggles
these modes. They are valid only for printing received documents.
(1)

Automatic reduction mode

• If the length of a received document exceeds the printable area, this mode cuts off the
document within the cutting length specified with the soft switch (MODE 007). If the
excess length is longer than the specified cutting off length, the document will be reduced
within the upper limit of reducing the size specified with the soft switch (MODE 007).
(2)

Cut off mode

• If the length of a received document exceeds the printable area, this mode cuts off the
document within the cutting length specified with the soft switch (MODE 007). (No reduc-
tion.)
4015M514AA
M-15