Table of Contents
Advertisement
7-4.
Protocol Trace
• Each communication processes information on a protocol trace.
.
27F51E5E
NSF
27F51F08
NSS
Note:
• Specify FCF names with capital letters for signals at 300 bps, otherwise use small letters.
• If the information of a single frame is longer than a single line, the next line will also be
used. This will be repeated as necessary.
• If there is no FCF name corresponds to the data in the FCF field, "?" will be displayed in
the FCF name field.
• If the information cannot be printed in a single sheet of a specified paper, the excess
information will be printed on the next paper.
(1)
Print by manual
1. Press the "Utility" key.
2. Press the Utility key.
3. Press the Meter Count key.
4. Press the following keys in this order:
Stop
0
0
5. Press the "Utility" key.
6. Press the "Report" key.
7. Press the "Report 1" key.
8. Press the "Protocol Trace" key.
7-5.
Network Protocol Trace
• Each communication processes information on a protocol trace.
If you wish to print it, go to the maintenance mode to press <Utility>. Then touch [Report 1]
to specify [Protocol Trace]
.
27F51E5E
27F51F08
Communication time
(decimal, 8 digit numbers)
FF 13 22 00 00 49 0C D2
FF 03 20 00 00 49 40 00 00 00 00 C8 C8 .... 34 7D 02
00 DA 80 7E 04 86 10 89 20 19 50 7C 20 .... 00 26 00
Command name
Stop
0
2
FF 13 22 00 00 49 0C D2
FF 03 20 00 00 49 40 00 00 00 00 C8 C8 .... 34 7D 02
00 DA 80 7E 04 86 10 89 20 19 50 7C 20 .... 00 26 00
When transmitting
When receiving
M-22
Data of each command
Each command data
Advertisement
Table of Contents
