Installing A Localtalk/Serial Module - Epson EPL-N2000 User Manual

If you will connect your printer to any type of serial interface,
you need to obtain the right kind of serial cable. EPSON supplies
several types of interface cables. However, you can use any
interface cable that meets the printer specifications listed below.
(See your computer manual for any special computer
requirements.)
Use this cable . . .
RS-232C (9 pin) to C836152 (2.0 m)
from mini DIN (printer) to D-SUB,
9-pin (computer)
RS-232C (25 pin) to C836151 (2.0 m)
from mini DIN (printer) to D-SUB,
25-pin (computer)
Current loop C836141 (0.4 m) from
mini DIN (printer) to D-SUB, 25-pin
(interface cable) for both RS-232C
and current loop
Also be sure to read "Using a Serial Interface" on page 4-12 for
instructions on configuring your computer and printer to work
correctly with a serial connection.

Installing a LocalTalk/Serial Module

Follow these steps to install the EPSON LocalTalk/Serial
module in your printer.
1. Turn off the printer and unplug the power cable from the
electrical outlet.
w
Warning:
To avoid electrical shock, do not access the printer's controller board
unless the printer is turned off and unplugged from the electrical
outlet.
2. Turn the printer so its back faces you and remove all
interface cables from the interface connectors.
For this serial connection . . .
Direct printer-to-computer with
9-pin serial ports
Direct printer-to-computer with
25-pin serial ports
Cable extension for printer-to-
interface connection
Installing Options 4-5