Epson EPL-N2000 User Manual page 42

EPL-N2000 driver settings (continued)
Time-out
Toner Save Mode
Low Power
Consumption
Auto Continue
Printer Options tab
Memory
Various settings from 5
to 300 seconds
(60 sec. default)
ON
OFF
ON
OFF
ON
OFF
4, 6, 8, 10, 12, 14, 16,
18, 20, 22, 24, 28, 36,
38, 40, 44, 52, 68 MB
Printing With the Windows Printer Drivers 2-11
Sets the amount of time the
printer waits to receive data
before terminating an
incomplete print job; after the
time-out period, another
print job can print.
Sets the amount of toner used
in your print job. If you're
printing a draft copy, set to
ON to use around 50% less
toner for a lighter printout.
Sets the printer to enter a
power-saving standby mode
if it is not used for 30 minutes.
(The printer takes about 1
minute to warm up after
exiting standby mode.)
Sets the printer to use Auto
Continue mode to continue
printing 5 seconds after
recovering from a print
overrun or insufficient
memory error. It is best to
leave Auto continue OFF so
you are alerted to errors; then
you must press the Continue
button on the control panel
to resume. If you'll be away
from the printer and are
aware of possible errors, you
can turn on Auto Continue
mode.
Specifies the amount of
memory installed in the
printer. Increase the number if
you add memory to your
printer.