Using SelecType
The SelecType button accesses a series of menus and options that
are shown on the control panel display. Although you can set
some of the SelecType options through your driver software or
through the Remote Control Panel utility, you need to use the
printer's control panel to access functions like the following:
Checking the amount of toner remaining
Changing the memory buffer size
Configuring interface channels
Changing emulation modes
Changing SelecType Settings
You can look at your current SelecType settings by printing a
status sheet. To do this, wait until the printer warms up (Ready
appears on the control panel display and the On Line light is on);
then press the Enter button twice.
Note:
Some application programs may send commands to your printer that
override SelecType settings. If you do not get the results you expect from
SelecType, check your application software settings to see if they affect your
output.
If you need to change SelecType settings, follow these steps:
1. Make sure the printer is turned on and the On Line light is
on.
Using the Control Panel 3-7