Removing The Duplex Unit - Epson EPL-N2000 User Manual

c
Caution:
Make sure that you tighten the screws all the way. If the Duplex
Unit pulls away, the unit or the printer may be damaged.
8. Connect any interface cables that you removed.
9. Plug the power cord into the printer and an outlet. Then turn
on the printer.
To verify that the unit is installed correctly, print a status sheet
and make sure it is listed under "Hardware Configurations."
Wait until the printer warms up; then press Enter twice.

Removing the Duplex Unit

Follow these steps to remove the Duplex Unit from the printer:
1. Turn off the printer and unplug the power cable from both
the printer and the electrical outlet.
2. Remove all interface cables from the interface connectors.
3. Remove the two screws that secure the unit to the printer.
c
Caution:
Make sure to support the unit as you remove it. It may
be damaged if it falls.
Installing Options 4-19