Table of Contents
Advertisement
PRE INSTALLATION
2.3
HANDLING AND TRANSPORTING CASES
The cabinets must be stored indoors, with a
temperature ranging between 0
humidity between 30% RH and 90% RH.
Before storing the cabinets, ensure packaging is
unbroken and does not display defects that may
compromise preservation of the cabinets.
Avoid UV rays:
Permanent deformation of plastic
materials or damage of cabinet
parts. DO NOT store the
in uncovered areas exposed to
atmospheric agents and to direct
sunlight.
Depending on model, the electrical
box is shipped attached to the back of
the case, or within the base deck along
with the other accessories.
2.4
SHIPPING DAMAGES AND SHORTAGES
Packaging needs to be disposed of
installer and/or user (refer to page 33).
Where possible please recylce as
many items as possible.
After removing packaging, inspect the case for any
shipping damage and ensure that all case inclusions
such as trims, etc., are accounted for. Immediately
report any shipping damage to the carrier and inform
Hussmann Customer Service of any short supplies.
Where possible all packaging and shipping braces
should be removed before cases are put into their
approximate final position.
•
Apparent loss or damage. If there is an obvious
loss or damage it must be noted on the
freight documentation receipt supplied by the
Transport Company and notified to Hussmann or
representative within seven (7) days of delivery.
PAGE 10
C and +40
C and a
0
0
cabinets
responsibly by the
•
Concealed loss or damage after removing all
packing, etc., is to be confirm with the parts list
attached to case for any short supplied and/or
damaged trims, product fences, etc. If required,
notify Hussmann or representative within seven (7)
days of delivery.
NOTE:
for all hazardous substances used
during installation in relation to their
application, PPE, first aid, disposal,
and emergency management. Refer
to page 36 for risk analysis. For
MSDS sheet contact your Hussmann
Representative.
CAUTION:
avoid damage to drainage outlets and
electrical equipment mounted under
or at the rear of cases.
INSPECT CASE BEFORE LIFTING
WITH FORKLIFT FOR LOCATION OF
ELECTRICAL BOX AND DRAIN PIPE.
CAUTION:
confirm that the equipment used is
approved for such works.
Do not lift or drag the case by the patch
end as this may damage both the case
and/or ends.
Refer to your companies' safe working
procedure (SWP) when handling cases
such as forklifts, trolleys, etc.
PMN20F3R MULTIDECK - HUSSMANN
Refer to product MSDS
Care must be taken to
When moving cases
Advertisement
Table of Contents
