Replacing Damaged Drain Fitting - Hussmann RFLNS Installation & Operation Manual

P/N 0539221_T
REPLACING DRAIN PAN HEATER —
ELECTRIC AND GAS DEFROST
(Low Temperature Only )
The drain pan heater is located as shown
below.
Remove Drain Pan Heater
1. Disconnect power.
2. Pull heater out from under retainer clips.
3. Position new heater under retainer clips.
Be sure offset is properly positioned
around the drain.
4. Reconnect power.
5. Verify that heater is working correctly.
Retainer Clip
Retainer
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Retainer Clip
Clip

REPLACING DAMAGED DRAIN FITTING

(OPTIONAL)
The following procedure is for the field repair
of a broken drain fitting.
1. Use a drill with a 1
saw to drill out the bottom of the drain fitting.
Be sure to drill completely through fitting and
bottom liner.
Drain Fitting Viewed from Inside Case
Drain Fitting
2. Insert adapter into drain fitting. Do NOT
Viewed from Inside Merchandiser
use thread sealer on ABS drain fitting. If sealer
is used the ABS drain fitting may crack or leak!
(Tee should be tightened no more than 4 turns.)
Do not overtighten threads.
Do NOT use Thread Sealer on Drain Fitting!
End Section View
Freedom Line Reach-in
/ -inch (48 mm) hole
7
8
6-3