Table of Contents
Advertisement
P/N 0539221_T
CARE AND CLEANING
Long life and satisfactory performance of
any equipment is dependent upon the care it
receives. To ensure long life, proper sanitation
and minimum maintenance costs, these
merchandisers should be thoroughly cleaned, all
debris removed and the interiors washed down,
weekly.
Always*Clear™ Glass
Wipe inside of glass with isopropyl alcohol and
a soft cloth. Allow surface to dry before closing
door. Use of other cleaners or abrasives may
damage the Always*Clear surface, and/or void
the warranty. Refer to manual that ships with
doors.
Exterior Surfaces
The exterior surfaces should be cleaned with
a mild detergent and warm water to protect
and maintain their attractive finish. n
abrasive cleansers or scouring pads
Interior Surfaces
The interior surfaces may be cleaned with most
domestic detergents, ammonia based cleaners
and sanitizing solutions with no harm to the
surface.
D
N
U
:
o
ot
se
• Abrasive cleansers and scouring pads, as
these will mar the finish.
• Solvent, oil or acidic based cleaners on any
interior surfaces.
• Ammonia based cleaners on acrylic surfaces.
Do NOT allow cleaning agent or
cloth to contact food product.
Product will be degraded and may spoil if
allowed to sit in a non-refrigerated area.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
MAINTENANCE
D
:
o
• Remove the product and all loose debris to
avoid clogging the waste outlet.
• Store product in a refrigerated area such
as a freezer. Remove only as much product
as can be taken to the freezer in a timely
manner.
• First turn off refrigeration, then disconnect
electrical power.
• Thoroughly clean all surfaces with soap
and hot water. d
high waTer pressure hoses To wash
The inTerior
merchandisers
and poor performance
• Remove screws and lift hinged fan plenum
for cleaning. b
ever use
the fan plenum after cleaning
.
merchandiser
• Take care to minimize direct contact
between fan motors and cleaning or rinse
water.
• Allow merchandisers to dry before
resuming operation.
• After cleaning is completed, turn on power
and refrigerant to the merchandiser.
• Verify that merchandiser is working
properly.
Do NOT use HOT water on COLD glass surfaces.
This can cause the glass to shatter and could
result in personal injury. Allow glass doors to
o noT use sTeam or
. t
hese will destroy the
'
sealing causing leaks
.
e sure to reposition
.
warm before applying hot water.
Freedom Line Reach-in
5-1
Advertisement
Table of Contents
