Installing Splashguards And Brackets - Hussmann RFLNS Installation & Operation Manual

FACADE, SPLASHGUARD AND BUMPERS
3-4
INSTALLING SPLASHGUARDS AND
BRACKETS
The splashguard is shipped inside each
merchandiser. a
fTer
been leveled and joined, and all drip piping,
electrical and refrigeration work has been
completed, re-install the splashguards.
Splashguards are joined with a galvanized
metal splice connector that comes with
the joint kit. Join the splashguards before
installing on case. The leveling brackets have a
maximum extension of one (1) inch (25 mm)
for uneven floors.
To install splashguards and brackets:
1. Slide the splashguard support bracket's
small flange into base rail slots. Next, slide the
splashguard retainer assembly under the case
as shown.
2. Rotate the retainer assembly clockwise
(from right hand side) while pulling towards
the front of the case, until the forward most
flange sits flush with the back of the color
panel.
3. Align the retainer assembly with and attach
to the support bracket using #10 screws. Then
install a #8 screw through the color panel into
the top retainer flange.
DO NOT
place shims under splashguard
.
brackeTs
P/N 0539221_T
merchandisers have
1.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Splashguards Installation
Splashguard
Splice Connector
1. S lide the s plas hguard s upport bracket's s mall flange into the
s lots in the bas e rail. T hen s lide the s plas hguard retainer
as s embly under the cas e as s hown.
2. R otate the retainer as s embly clockwis e (from right hand s ide)
Side
Detail
1. S lide the s plas hg
s lots in the bas e
as s embly under
2. R otate the retain
while pulling tow
mos t flange s its
2.
3. Align the retaine
bracket us ing #1
color panel into t
3.
1.
s
a
2.
w
m
3.
b
c