Table of Contents
Advertisement
P/N 0539221_T
CLEANING CONDENSATE PUMP AND
HEATED EVAPORATION PANS
(for case with field-installed option)
a
lways disconnect power at the main
case disconnect before servicing the
.
equipment
These items are optional items and are not
provided with the case.
• The condensate water outlet for the self-
contained models empties into a limited
capacity evaporation pan.
• Clean product spills immediately. If a product
spill enters the Condensate Pump or Heated
Evaporation Pans, a maintenance technician
may be required to clean both the pump and
heated pans.
• Clean case interior with a sponge or soft
cloth, wetted with mild soap and water. Do
not pour water from a bucket or hose into case
drain. Water introduced during cleaning will
cause the evaporation pan to overflow.
• Sediment and debris will clog the Condensate
Pump and plastic tubing for water delivery to
the Heated Evaporation Pans.
• The Condensate Pump and the Heated
Evaporation Pans require regular monthly
inspection. The Condensate Pump is located
below the case bottom. The Heated Evaporation
Pans are located on the case top. Evidence
of excess water or odor is an indication that
immediate service is required.
• It is recommended to clean the Condensate
Pump and Heated Evaporation Pans with
mild soap and water. Disconnect power before
cleaning. Empty pump sump and heater pans
of water before reapplying power.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Evaporation Pan is Hot!
and poses risk of bodily injury
— Always wear gloves and
protective eye wear when
servicing condensate pump and
heated evaporation pans. Turn off
evaporation pan heater, and allow
pan to cool before servicing.
CLEANING UNDER MERCHANDISERS
Remove splashguards not sealed to floor.
Use a vacuum with a long wand attachment
to remove accumulated dust and debris from
under the merchandiser.
conditions may cause condensation and therefore
sweating of doors. Facility operators should
monitor doors and floor conditions to ensure
safety of persons.
REMOVING SCRATCHES FROM BUMPER
Most scratches and dings can be removed using
the following procedure.
1. Use steel wool to smooth out the surface
area of the bumper or top rail.
2. Clean area.
3. Apply vinyl or car wax and polish surface
for a smooth glossy finish.
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electrical
shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
Freedom Line Reach-in
5-3
Excessive ambient
Advertisement
Table of Contents
