Memory Locations and Replacement Procedures
Figure B-3
➀
DIMM
DIMM Replacement Procedure (7G4282-41 only)
Removing the DIMM from 7G4282-41
To remove the DIMM from the 7G4282‐41, proceed as follows:
1.
If an optional NEM is installed on the main board of the 7G4282‐41, refer to Figure
on page B‐5 and proceed to step 1a. Otherwise proceed to step 2.
a.
B-4
Mode Switch Bank Settings and Optional Installations
Memory Module Locations on the 7G4282-41
➁
DRAM SIMM
Note: The following DIMM replacement instructions apply to the 7G4282-41 only. The
DIMM is not considered a field replaceable part on the 7G4202-60. Contact
Enterasys Networks support if this part fails and needs a replacement.
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
Note: Prior to removing the DIMM from a 7G4282-41, you must remove the network
expansion module (NEM
Remove and save the three screws attaching the NEM to the front panel.
➂
to gain access to the DIMM memory and connector.
)
Â
Á
À
À
Main PC board
Â
Á
B‐4