Table of Contents
Advertisement
Figure 6 LEDs on the EMG8726-B10A
1.4.2 LEDs (Lights)
The following table describes the LEDs.
None of the LEDs are on if the EMG is not receiving power.
Table 2 EMG6726-B10A LED Descriptions
LED
Power
Internet
Chapter 1 Introducing the EMG
COLOR
STATUS
DESCRIPTION
Green
On
The EMG is receiving power and ready for use.
Blinking
The EMG is self-testing.
Red
On
The EMG detected an error while self-testing, or there is a device
malfunction.
Blinking
The EMG is uploading firmware.
Off
The EMG is not receiving power.
Green
On
The EMG has an IP connection but no traffic.
Blinking
The EMG is sending or receiving IP traffic.
Off
There is no Internet connection or the gateway is in bridged mode.
Red
On
The EMG attempted to make an IP connection but failed. Possible causes
are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.
EMG6726/8726-B10A User's Guide
21
Advertisement
Table of Contents
