ZyXEL Communications EMG8726-B10A User Manual page 22

Table 2 EMG6726-B10A LED Descriptions (continued)
LED COLOR
Green
LAN/WAN
Green
Ethernet 1~4
Note: The USB LED is reserved for future development.
USB
Green
WiFi 2.4G
WiFi 5G
Amber
Amber
WPS
Table 3 EMG8726-B10A LED Descriptions
LED COLOR
Green
Power
Red
Green
Internet
Red
Green
WAN
Green
Ethernet
Chapter 1 Introducing the EMG
STATUS DESCRIPTION
On The EMG has a successful 10/100/1000 Mbps Ethernet connection on the
WAN.
Blinking The EMG is sending or receiving data to/from the WAN at 10/100/1000
Mbps.
Off There is no Ethernet connection on the WAN.
On The EMG has a successful 10/100/1000 Mbps Ethernet connection with a
device on the Local Area Network (LAN).
Blinking The EMG is sending or receiving data to/from the LAN at 10/100/1000 Mbps.
Off The EMG does not have an Ethernet connection with the LAN.
On The 2.4 GHz or 5 GHz wireless network is activated.
Blinking The EMG is communicating with 2.4 GHz or 5 GHz wireless clients.
Blinking The EMG is setting up a WPS connection with a 2.4 GHz or 5 GHz wireless
client.
Off The 2.4 GHz or 5GHz wireless network is not activated.
On WPS is enabled.
Off WPS is disabled.
STATUS DESCRIPTION
On The EMG is receiving power and ready for use.
Blinking The EMG is self-testing.
On The EMG detected an error while self-testing, or there is a device
malfunction.
Blinking The EMG is uploading firmware.
Off The EMG is not receiving power.
On The EMG has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the DSL
connection is up.
Blinking The EMG is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged mode.
On The EMG attempted to make an IP connection but failed. Possible causes
are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.
On The EMG has a successful 10/100/1000 Mbps Ethernet connection on the
WAN.
Blinking The EMG is sending or receiving data to/from the WAN at 10/100/1000
Mbps.
Off There is no Ethernet connection on the WAN.
On The EMG has a successful 10/100/1000 Mbps Ethernet connection with a
device on the Local Area Network (LAN).
Blinking The EMG is sending or receiving data to/from the LAN at 10/100/1000 Mbps.
Off The EMG does not have an Ethernet connection with the LAN.
EMG6726/8726-B10A User's Guide
22