Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 39 Network Setting > QoS > General
LABEL
QoS
WAN Managed
Upstream
Bandwidth
LAN Managed
Downstream
Bandwidth
Upstream Traffic
Priority Assigned
by
Apply
Cancel
10.4 The Queue Setup Screen
Click Network Setting > QoS > Queue Setup to open the screen as shown next.
Use this screen to configure QoS queue assignment.
Chapter 10 Quality of Service (QoS)
DESCRIPTION
Select the Enable check box to turn on QoS to improve your network performance.
Enter the amount of upstream bandwidth for the WAN interfaces that you want to allocate using
QoS.
The recommendation is to set this speed to match the interfaces' actual transmission speed. For
example, set the WAN interfaces' speed to 100000 kbps if your Internet connection has an
upstream transmission speed of 100 Mbps.
You can also set this number lower than the interfaces' actual transmission speed. This will cause
the EMG to not use some of the interfaces' available bandwidth.
If you leave this field blank, the EMG automatically sets this number to be 95% of the WAN
interfaces' actual upstream transmission speed.
Enter the amount of downstream bandwidth for the LAN interfaces (including WLAN) that you
want to allocate using QoS.
The recommendation is to set this speed to match the WAN interfaces' actual transmission
speed. For example, set the LAN managed downstream bandwidth to 100000 kbps if you use a
100 Mbps wired Ethernet WAN connection.
You can also set this number lower than the WAN interfaces' actual transmission speed. This will
cause the EMG to not use some of the interfaces' available bandwidth.
If you leave this field blank, the EMG automatically sets this to the LAN interfaces' maximum
supported connection speed.
Select how the EMG assigns priorities to various upstream traffic flows.
•
None: Disables auto priority mapping and has the EMG put packets into the queues
according to your classification rules. Traffic which does not match any of the classification
rules is mapped into the default queue with the lowest priority.
•
Ethernet Priority: Automatically assign priority based on the IEEE 802.1p priority level.
•
IP Precedence: Automatically assign priority based on the first three bits of the TOS field in the
IP header.
•
Packet Length: Automatically assign priority based on the packet size. Smaller packets get
higher priority since control, signaling, VoIP, internet gaming, or other real-time packets are
usually small while larger packets are usually best effort data packets like file transfers.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
EMG6726/8726-B10A User's Guide
137
Advertisement
Table of Contents
