How To Save And Replay The Data - Furuno FR-1908V-BB Operator's Manual

1. OPERATION
How to set an SD card
The processor unit has two slots for SD cards. The [SD-1] is upper slot and [SD-2] is
lower.
1. Pull the tab on the card drive on the processor unit to open the card drive.
2. Put the SD card in the either card drive, [SD-1] or [SD-2], with the label upward. If
the card does not set easily, do not use force.
3. Push the card until the card is in position.
How to remove an SD card
To remove an SD card, select [SD-1] or [SD-2] from the [REMOVE EXTERNAL
MEDIA] menu. There are two methods to open [REMOVE EXTERNAL MEDIA] as
follows.
• [MAIN MENU]–[FILES]–[REMOVE EXTERNAL MEDIA]
• [MAIN MENU]–[CAPTURE]–[REMOVE EXTERNAL MEDIA]
1. On [FILES] or [CAPTURE] menu, select [REMOVE EXTERNAL MEDIA].
2. Select the SD card to remove, [SD-1] or [SD-2].
Note: Select the same card as the card selected on the [DRIVE SELECT] menu.
3. Pull the tab on the card drive cover to open the card drive.
4. Push the card to release the card from the card drive.
5. Remove the card with your fingers then close the cover.
Note: Always remove an SD card by this method to prevent non-recognition of the
card the next time when it is inserted. If a card is not recognized, insert the card again
and do the above operation.
1.35.2

How to save and replay the data

All SD card operations begin from the [FILES] menu.
The [FILES] menu is available in stand-by mode.
The data witch is saved in the FR-1908V-BB/FR-
1918V-BB do not have the compatibility with other
models. Do not let the data read to the other models,
and also do not let other models read the data of the
FR-1908V-BB/FR-1918V-BB. It may cause the mal-
function.
Note: All settings, except for [BRILL 1-1] and
radar is turned off. If you want to keep all settings, including [BRILL 1-1] and [CUS-
TOM 1-1], save the settings to an SD card before turning off the radar. Then replay
the saved settings after turning on the radar.
• [DRIVE SELECT]: Click the drive [SD-1] or [SD-2] to use. The [SD-1] is upper slot
and [SD-2] is lower.
• [DRIVE INFO]: Confirm the remaining capacity of the SD card selected at [DRIVE
SELECT].
1-58
[FILES]
1 BACK
2 DRIVE SELECT
SD-1 /SD-2
3 [DRIVE INFO]
4 [SAVE DATA]
5 [REPLAY (READ) DATA]
6 [DELETE DATA]
7 REMOVE EXTERNAL MEDIA
SD-1 /SD-2
[CUSTOM 1-1], are stored when the