Offset Ebl; How To Measure The Range And Bearing Between Two Targets - Furuno FR-1908V-BB Operator's Manual

1.20

Offset EBL

How to offset an EBL
You can move the EBL origin to a desired location as follows:
1. Put the cursor on the appropriate [EBL] icon to activate the EBL. The mark (>),
which denotes active EBL, moves to the [EBL] icon selected. The example below
shows how to activate the EBL1.
">" means active.
>
EBL2 is active.
2. Right-click anywhere in the radar display to open [CURSOR MENU].
3. Click [EBL OFFSET].
4. Click anywhere in the radar display to move the EBL origin with cursor.
5. Click the point where to fix the EBL origin there.
6. To return the EBL origin to own ship position, click anywhere in the radar display
again.
7. Right-click to quit the offset EBL.
1.20.1

How to measure the range and bearing between two targets

You can move the origin of the EBL to measure the range and bearing between two
targets.
1. Click the [EBL1] icon to activate EBL1. If the EBL already appears, go to step 2.
2. Right-click anywhere in the radar display to open [CURSOR MENU].
3. Click [EBL OFFSET].
4. Click anywhere in the radar display to move
the EBL origin.
Note: If EBL1 is already off-centered, the ori-
gin of the EBL moves to own ship's position
once. In this case, click anywhere in the radar
display again.
5. Click the center of the target A to fix the EBL.
6. Right-click to quit the offset EBL.
7. Click the [EBL1] icon to change the
bearing. The [EBL1] icon turns
yellow.
123.4° 123.4°
T
EBL1 EBL1
82.9°
EBL2
T
Put the cursor on
the [EBL1] icon.
123.4° 123.4°
> EBL1 EBL1
82.9°
EBL2
">" move to the
[EBL1] icon
EBL1 EBL1
Target B Target B
Target A Target A
EBL origin
Click
123.4° 123.4°
T
EBL1 EBL1
82 9°
1. OPERATION
T
T
123.4° 123.4° T
EBL1 EBL1
82 9°
Highlighted yellow
1-23