Table of Contents
Advertisement
3.
Insert the dipstick all the way into
the transmission as shown.
Remove the dipstick and check
4.
the fluid level. It should be
between the upper and lower
marks.
5.
If the level is below the lower
mark, add fluid into the dipstick
hole to bring it to the level
between the upper and lower
marks.
Pour the fluid slowly and carefully so
GUIDE
you do not spill any. Clean up any
spill immediately; it could damage
components in the engine
compartment.
Always use Acura ATF DW-1
(automatic transmission fluid).
UPPER
MARK
LOWER
MARK
Use only Acura ATF DW-1 (automatic
transmission f luid). Do not mix with
other transmission f luids.
Using transmission f luid other than
Acura ATF DW-1 may cause
deterioration in transmission operation
and durability, and could result in
damage to the transmission.
Damage resulting f rom the use of
transmission f luid other than Acura
ATF DW-1 is not covered by the Acura
new vehicle warranty.
Automatic Transmission Fluid
6.
Insert the dipstick all the way back
into the transmission securely as
shown in the illustration.
Make sure the rubber cap on the
dipstick fits in the dipstick guide
and that you push the dipstick in
all the way.
The transmission should be drained
and refilled with new fluid when this
service is shown by a maintenance
message on the multi-information
display.
If you are not sure how to add fluid,
contact your dealer.
465
Advertisement
Chapters
Table of Contents
