Table of Contents
Advertisement
Keyless Access System
Recalling a Memorized Driving
Position
DRIVER'S ID
When you unlock the driver's door
with your remote transmitter, each
remote transmitter activates the
customized settings related to that
remote.
The driving position memory
activated (Driver 1, Driver 2) is
shown on the back of each remote.
Make sure you store your desired
driving position in the memory that
174
is activated by the remote you
normally carry.
Here are the settings activated with
the remote:
Driving position memory
(see page
164
).
Customized settings
(see page
81
).
Audio system settings
(see page
213
).
Climate control settings
(see page
205
).
U.S. RL model
Compass system preferences
(see page
281
).
Except U.S. RL model
Navigation system preferences
(see the navigation system
manual).
To turn off this feature, press and
hold the LOCK and UNLOCK
buttons at the same time. The LED
in the remote will blink once. Then
release the buttons. Doing this
cancels the keyless memory settings
for that remote and restores the
default settings.
Some of them keep the same
settings as they were set previously.
To turn the keyless memory settings
back on, repeat this procedure. The
LED will blink twice to indicate the
feature has been turned on.
When you unlock and open the
driver's door with the remote, the
driver's seat (except power lumbar)
and outside mirrors move to the
positions stored in memory. An
indicator on one of the driving
position memory buttons on the
driver's door also comes on.
Advertisement
Chapters
Table of Contents
