Acura 2011 RL Owner's Manual page 244

Audio System
Manufactured under license under
U.S. Patent ＃ 's: 5,451,942; 5,956,674;
5,974,380; 5,978,762; 6,487,535 &
other U.S. and worldwide patents
issued & pending. DTS and DTS
Digital Surround are registered
trademarks and the DTS logos and
Symbol are trademarks of DTS, Inc.
1996-2008 DTS, Inc. All Rights
Reserved.
You cannot load and play 3-inch
(8-cm) discs in this system.
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
238
Loading Discs in the Changer
To load multiple discs in one
operation:
1. With the ignition switch in the
ACCESSORY (I) or ON (II)
position, press and hold the LOAD
button until you hear a beep. You
will see ''LOAD'' on the upper
display.
Insert the disc into the disc slot
2.
when the disc load indicator turns
green and ''LOAD'' appears in the
upper display at the same time.
Insert it only halfway; the drive
will pull it in the rest of the way.
You will see ''BUSY'' on the upper
display, and the disc load indicator
turns red again and blinks as the
disc is loaded.
3. When the disc load indicator turns
green and ''LOAD'' appears on the
upper display again, insert the
next disc in the slot.
Do not try to insert a disc until
''LOAD'' appears. You could
damage the audio unit.
4. Repeat this until all six positions
are loaded. If you are not loading
all six positions, the system will
then begin playing the last disc
loaded.
If you stop loading discs before all
six positions are filled, the system
will wait for 15 seconds, stop the load
operation, and begin playing the last
disc loaded.
To load a single disc:
1. Press and release the LOAD
button on the changer unit. You
will see ''BUSY'' on the upper
display, and the disc load indicator
turns red and starts blinking.