Figure 6–10 Removing a Cooling Module (2)
Important
The cooling module bay must not be empty for more than two minutes while the enclosure is
powered.
6.4.2 Inserting a Cooling Module
Rotate the cooling module so that the black release latch and handle are on the right-hand side.
1
Slide the cooling module into its slot until the latch clicks home. The enclosure will automatically detect
2
and make use of the new unit.
6.5 Replacing a Power Supply Unit (PSU)
6.5.1 Removing a PSU
Important
Before removing a PSU, make sure you have a replacement module to insert.
1
Identify the PSU to be removed using appropriate fault reporting software.
2
As shown in
pull the module out by its handle (2).
Figure 6–11
and
Figure
6–12, push the red release latch to the right and hold it (1), then
Module Replacement
51