6.6.2 Inserting an SBB I/O Module
Rotate the SBB I/O module so that the release latch is at the bottom.
1
Open the release latch and rotate it to its most open position (as shown in
2
Slide the I/O module into its slot until it will go no further and the handle has started to close.
3
4
Close the latch until it clicks home. This will lever the module home into its connector on the midplane.
The enclosure will automatically detect the new unit.
Connect the cables to the new module (if necessary, refer to the note you made before you removed the
5
cables from the defective I/O module).
Module Replacement
Figure
6–15).
55