Page 1
Video 3.5 HDD SATA Product Manual ST1000VM002 100780435, Rev. A August 2015...
Page 2
United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners. No part of this publication may be reproduced in any form without written permission of Seagate Technology LLC. Call 877-PUB-TEK1 (877-782-8351) to request permission.
Authorized Service Centers For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit http://www.seagate.com/services-software/seagate-recovery-services/ recover/ For Seagate OEM and Distribution partner portal, visit: http://www.seagate.com/partners/ For Seagate reseller portal, visit: http://www.seagate.com/partners/ Seagate Video 3.5 HDD Product Manual, Rev. A...
Serial ATA devices behave like Device 0 devices. For additional information about how Serial ATA emulates parallel ATA, refer to the “Serial ATA International Organization: Serial ATA Revision 3.0”. The specification can be downloaded from www.sata-io.org. Seagate Video 3.5 HDD Product Manual, Rev. A...
Weight (typical) 5.1ms Average latency <6s Power-on to ready (max) <6s Standby to ready (max) <1.0ms read; Track-to-track seek time (typical) <1.2ms write <12.0ms Average seek (typical) 1.6A Startup current (typical) 12V (peak) Seagate Video 3.5 HDD Product Manual, Rev. A...
Page 9
*One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. **During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels Seagate Video 3.5 HDD Product Manual, Rev. A...
2.7 Start/stop times Start/stop times @ 25°C 1TB model Power-on to ready (max) < 6.0s Standby to ready (max) < 6.0s Ready to spindle stop (max) 10.0s Seagate Video 3.5 HDD Product Manual, Rev. A...
*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Measurement was taken in Idle 1 mode. †5W IDLE, Standby and Sleep, with DIPLM enabled Seagate Video 3.5 HDD Product Manual, Rev. A...
Standby mode. In both Idle and Standby mode, the drive accepts all commands and returns to Active mode when disk access is necessary. Seagate Video 3.5 HDD Product Manual, Rev. A...
2.9.3.2 Wet bulb temperature Operating 37.7°C (99.9°F max) Nonoperating 40°C (104°F max) 2.9.4 Altitude Operating –60.96m to 3048m (–200 ft. to 10,000+ ft.) Nonoperating –60.96m to 12,192m (–200 ft. to 40,000+ ft.) Seagate Video 3.5 HDD Product Manual, Rev. A...
2.2 bels (typ) ST1000VM002 2.1 bels (max) 2.3 bels (max) *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Seagate Video 3.5 HDD Product Manual, Rev. A...
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses this threshold curve (originated in ISO 389-7) to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
EN55022, Class B and the immunity levels are defined by EN55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports.
As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules.
The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%.
For installations which require cables, users can connect the drive as illustrated in Figure 3 Figure 3 Attaching SATA cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Video 3.5 HDD drives support latching SATA connectors. Seagate Video 3.5 HDD Product Manual, Rev. A...
• Do not overtighten the mounting screws (maximum torque: 6 in per lb). Note. Image is for reference only, and may not represent actual drive. Figure 4 Mounting dimensions (1TB model) Note. Image is for reference only, and may not represent actual drive. Seagate Video 3.5 HDD Product Manual, Rev. A...
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind- mate backplane configuration. All used voltage pins (V ) must be terminated. Seagate Video 3.5 HDD Product Manual, Rev. A...
0200 Retired 0200 Words 54–58, 64–70 and 88 are valid 0007 Number of current logical cylinders xxxx Number of current logical heads xxxx Number of current logical sectors per logical track xxxx Seagate Video 3.5 HDD Product Manual, Rev. A...
Page 29
= 1000000100101 binary) Command sets enabled 34xx Command sets enabled BE01 Command sets enable extension 4133 Ultra DMA support and current mode (see note following this 00A4 table) Security erase time 00A4 Seagate Video 3.5 HDD Product Manual, Rev. A...
Page 30
Multiword DMA mode 1 is supported. Multiword DMA mode 2 is supported. Multiword DMA mode 0 is currently active. Multiword DMA mode 1 is currently active. Multiword DMA mode 2 is currently active. Seagate Video 3.5 HDD Product Manual, Rev. A...
Page 31
Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Seagate Video 3.5 HDD Product Manual, Rev. A...
Disable use of SATA features. Enable read look-ahead (read cache) feature (default). Report full capacity available. At power-on, or after a hardware or software reset, the default values of the features are as indicated above. Note Seagate Video 3.5 HDD Product Manual, Rev. A...
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the command is aborted and 0x 04 (abort) is Note written to the Error register. Seagate Video 3.5 HDD Product Manual, Rev. A...
Page 34
ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100780435, Rev. A...