Seagate OneStor SP-3584 Installation & User Manual page 22

OneStor® SP-3584 Installation & User Guide
2.3.3.2 Input Switch
Used to set the unit identification display (see section
Number", on page
2.3.3.3 Power On/Standby LED (Green/Amber)
Shows amber when the system is in standby (not operational). Shows green when the system is on
(operational).
2.3.3.4 Module Fault LED (Amber)
Shows amber when there is a system hardware fault. Additionally, an LED may be lit on a PSU, drawer,
DDIC, cooling module or I/O module that helps you identify which component is at fault.
2.3.3.5 Logical Status LED (Amber)
Indicates a change of status or fault from something other than the enclosure management (EM) system.
This may be from an internal or external RAID controller or HBA. It is usually associated with a disk
drive and LEDs at each disk drive position help you identify the drive affected.
2.3.3.6 Drawer Fault LEDs (Amber)
Indicates a drive, cable or sideplane fault in the drawer indicated.
14
31).
4.4.1, "How To Set the Unit Identification