Replacing An Sbb I/O Module; Removing An Sbb I/O Module - Seagate OneStor SP-3584 Installation & User Manual

2 Slide the PSU into its slot until the latch clicks home. The enclosure will automatically detect the new
unit.

6.6 Replacing an SBB I/O Module

Important Before removing an SBB I/O module, make sure you have a replacement module to insert.
A variety of I/O modules can be used in the enclosure. These procedures show a 
Note
12Gb/s SAS EBOD I/O module.

6.6.1 Removing an SBB I/O Module

Identify the SBB I/O module to be removed. If the module has failed, the fault LED will be lit amber
1
(see Figure
Make a note of the locations of the cables before removing them from the I/O module.
2
Figure 6–13 SBB I/O Module LEDs (12Gb/s SAS EBOD module shown)
As shown in
3
you (1). This will lever the module out of its connector on the midplane.
Pull the module out of the enclosure (2).
4
6–13).
Figure 6–14 and Figure 6–15, pinch the latch on the module and pull the handle towards
Module Replacement
53