Industry Compliance - Crestron Isys TPS-4L Operations & Installation Manual

®
Crestron Isys TPS-4L
LAN
Yellow Green
LED
1 8
Operations & Installation Guide – DOC. 6449
To access the reset button, remove the bezel and then use a narrow blunt instrument
such as the end of a ballpoint pen to press the button.
CAUTION: Do not attempt to press the reset button by inserting a paperclip or
similar device through the small hole in the bezel. This could cause physical damage
to the button or a short circuit on the printed circuit board.
LAN
An 8-wire RJ-45 connector with two LED indicators (green LED indicates link
status, yellow LED indicates Ethernet activity). This connector provides an
Ethernet 10baseT /100baseTX, full duplex, TCP/IP, UDP/IP, CIP, IEEE 802.3U
compliant network connection for the TPS-4L touchpanel.
LED
NOTE: This port does not support a wireless Ethernet connection.
LAN Connector Pinout
PIN
1
2
3
4

Industry Compliance

As of the date of manufacture, the TPS-4L has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
3.6-inch Wall Mount Touchpanel
Reset
Button
SIGNALS
TX +
TX -
RC+
N/C
3.6-inch Wall Mount Touchpanel: Isys
PIN SIGNALS
5 N/C
6 RC -
7 N/C
8 N/C
TPS-4L • 5
®